|
|
|
|
|
 |
耐高温(阻燃)电力电缆FF22 (ZR)-FG (ZR)-FV22
|
 |
|
|
|
|
产品名称：耐高温(阻燃)电力电缆FF22 (ZR)-FG (ZR)-FV22
产品编号：Pro20091214165624
产品型号：FF22 (ZR)-FG (ZR)-FV22
市场价格：面议 元/米
批发价格：面议 元/米
更新时间：2009.12.14
出品单位：特种电缆
浏览次数：
更多产品图片：
|
 |
|
 产品详细介绍 |
耐高温(阻燃)电力电缆
High Temperature Resistant (Flame Retardant)
Power Cable
本产品适用于额定电压0.6/1kV及以下的高温范围和恶劣
环境内，作电气设备电能传输线。
It is used as power transmission cable for electric
equipments of rated voltage 0.6/1kV or lower in bad
environment or that with high temperature.
一、生产执行标准 采用企业标准Executive standard: enterprise standard
二、使用特性 Performance in Usage
1、额定电压UO/U: 0.6/1kV。
2、电缆允许最高工作温度: 氟塑料绝缘及护套为200℃；
氟塑料绝缘耐热105聚氯乙烯护套为105℃；氟塑料绝缘硅橡
胶护套为180℃。
3、短路时(最长持续间不超过5S)电缆导体的最高温度不
超过250℃。
4、电缆敷设温度应不低于-15℃。
5、电缆的弯曲半径如下：单芯电缆：其弯曲半径不小于
电缆外径的20D。
三芯电缆:其弯曲半径不小于电缆外径的15D。
6、氟塑料绝缘及护套型电力电缆具有优异的耐化学腐蚀
性、耐高温及阻燃性。
1: Rated voltage UO/U: 0.6/1kV
2: Max.working temperature allowed by cable is
200℃ for cable with fluoroplastic insulation and sheath,
105℃ for cable with fluoroplastic insulation，105℃ heat
resistanc and PVC sheath, and 180℃ for cable with fl uoroplastic
insulation and silicon rubber sheath.
3: Max temperature of cable conductor is no more
than 250℃ during short circuit (The longest lasting time is
no more than 5s).
4: Temperature for installation is no less than -15℃.
5: Bending radius of cable as follows:
It is no less than 20 times that of cable outer diameter
for cable with single core
It is no less than 15 times that of cable outer diameter
for cable with 3 cores
6: Power cable with fluoroplastic insulation and
sheath has good features of chemical corrosion resistance,
high temperature resistance and fl ame retardance.
三、电缆的型号名称 Type and Description
1、电缆的型号名称如表1 Type and Description in Table 1
Table 1
型 号
Type
名 称
Description
FF 聚全氟乙丙烯绝缘护套耐高温电力电缆
High temperature resistant power cable with F46 insulation and sheath
FF22 聚全氟乙丙烯绝缘护套钢带铠装耐高温电力电缆
High temperature resistant power cable with F46 insulation and sheath, steel tape armoring
(ZR)-FG 聚全氟乙丙烯绝缘(阻燃)硅橡胶护套耐高温电力电缆
High temperature resistant power cable with F46 insulation ( fl ame retardant)and silicon rubber sheath
(ZR)-FG22
聚全氟乙丙烯绝缘(阻燃)硅橡胶护套钢带铠装耐高温电力电缆
High temperature resistant power cable with F46 insulation ( fl ame retardant), silicon rubber sheath and steel tape
armoring
(ZR)-FV
聚全氟乙丙烯绝缘(阻燃)耐热105聚氯乙烯护套耐高温电力电缆
High temperature resistant power cable with F46 insulation ( fl ame retardant), 105℃ heat resistance and PVC
sheath
(ZR)-FV22
聚全氟乙丙烯绝缘(阻燃)耐热105聚氯乙烯护套钢带铠装耐高温电力电缆
High temperature resistant power cable with F46 insulation ( fl ame retardant), 105℃ heat resistance , PVC sheath
and steel tape armoring
注：型号中“22”表示钢带铠装，如需钢丝铠装结构应将型号中的“22”改为
“32”即可。
Note: 22 means steel tape armor “22”should be changed into “32”for
cable with steel wire armor (if needed).
www.tiankang.com 116
四、电缆规格 Specifi cation of Cable
电缆规格表示为芯数×导体标称截面mm2,其芯数及导
体标称截面如表2
“core number * nominal cross section” stands for
cable specification. Please see the following table 2 for
core number and nominal cross section
Table 2
型 号
Type
芯 数
Core number
标称截面 mm2
Nominal cross section area
FF
1、2、3、4、5、
3+2、3+1
1.5～95
FF22 2.5～70
(ZR)-FG、(ZR)-FV 1.5～240
(ZR)-FG22、(ZR)-FV22 2.5～240
五、技术参数 Technical Parameter
1、20℃导体直流电阻应符合GB/T3956标准规定。
2、电缆应经受3500V交流耐压试验5min绝缘不击穿。
1: DC resistance of conductor at 20℃ shall meet
the requirement of GB/T3956 standard.
2: Cable shall bear AC voltage test of 3500V for
5min without puncture of insulation.
六、交货长度 Delivery length
允许根据双方协议长度交货；长度计量误差不超过±
0.5%。
Delivery length of cable depends on both agreements
with length error allowance of ±0.5%
ANHUI | |
|
|
| |
|
|
|
|
|
